Custom Resolution Utility (CRU)
|
02-25-2020, 10:12 PM
(Last edited: 02-25-2020, 10:15 PM by apav)
Post: #4531
|
|||
|
|||
RE: Custom Resolution Utility (CRU)
(02-25-2020 09:54 PM)ToastyX Wrote:(02-25-2020 08:05 PM)apav Wrote: Before I saw this reply, I tried deleting my resolutions in CRU and recreating them Nvidia Control Panel using the CVT reduced blank setting. I don't seem to be having the artficating issue with this custom resolution, but the pixel clock is about 23Mhz higher than the one I had in CRU."LCD standard" will give you the same timing parameters as CVT reduced blank. That should allow the memory clock to change without artifacts. You can try for a lower pixel clock, but it's not necessary if you're not having any problems. Thanks. I'm just trying to maximize the lifespan of the monitor as much as I can while retaining this overclock. Does a higher pixel clock result in more wear, or does that happen only when using a higher overclocked refresh rate? |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 97 Guest(s)